Which material suits my kitchen countertop?
It depends on your use: porcelain is the toughest and maintenance-free, quartz is uniform and easy to clean, and granite and quartzite are very hard natural stones. Our advisor suggests the ones that fit you.
How much does a made-to-measure countertop cost?
The price depends on the material (porcelain, quartz, granite or quartzite), the linear metres and the type of edge and finish. That is why we quote a fixed price from your measurements: tell us about your kitchen in the advisor and we give you a figure with no commitment and no surprises later.
How is it different from a big DIY-store countertop?
At a big store you buy a standard product; we fabricate the piece to measure in our workshop in Puente Genil, with the material and edge you choose, adjusted to the millimetre to your kitchen and with our own installation. You gain in finish, in durability and in having someone accountable for the whole job.
Do you make everything to measure?
Yes. Every piece is made to measure in our own workshop in Puente Genil and we install it ourselves.
My new hob does not fit the cut-out in my worktop. Can you enlarge it?
Yes, it is work we do, and always at your home: the worktop is bonded to the units and cannot be taken to the workshop. But you should know up front that it is not always possible. It depends on the material, the condition it is in, the space left between the cut-out and the edge or the sink, and the risk of breakage: the area around an existing cut-out is exactly where the worktop is weakest, and enlarging it is not always viable. To tell you whether it can be done in your case, send us photos of the cut-out and of the whole worktop by WhatsApp, the current opening size, the size of the new hob and, if you know it, what the worktop is made of. We will answer from that. And if we can see it cannot be done, we will say so: we would rather lose the job than break your worktop.
How much dust does cutting a worktop at home create? Who cleans up?
A lot, and we would rather tell you before we come than afterwards. In the workshop we cut with water, which is what keeps the dust down, but on a worktop that is already installed that is not possible: the cut has to be dry, and that is where the dust comes from. It is very fine and it travels through the whole house; we vacuum as we cut, but some of it escapes anyway. The split is this: you prepare the area beforehand — sealing openings, protecting units and appliances and providing ventilation — and you handle the cleaning afterwards; we bring the machine, the extraction and the operator's protective gear. Two tips for that cleaning: use a vacuum and a damp mop rather than sweeping dry, because a broom lifts the fine dust again; and keep everyone away from the work area. And to be clear: the dust only exists during the cut. An installed worktop gives off nothing.
How do I request a quote?
Through the countertop advisor, via WhatsApp or on the contact page, with your measurements or plans.