We make your shower tray to the exact size of the opening in Córdoba and the Costa del Sol, in compact micro-marble 20 and 30 mm thick with a bush-hammered anti-slip finish. No standard sizes: if your bathroom needs 87 cm, the tray is 87 cm.
Free study and quote — we advise you before you decide.
Every piece is cut to the exact size of your opening. Send us the width and the length and we will confirm the options that fit.
See this type of work by material:
Something shops rarely explain: micro-marble contains resin too. Both are the same family of material — resin plus mineral filler — so the difference is not in the name. It is in three things you can actually measure, and a fourth we would rather tell you before you find it out yourself.
Our micro-marble has a density of 2,400 to 2,500 kg/m³: an 80×120 tray at 30 mm weighs around 70 kg, and around 47 kg at 20 mm. A standard resin tray runs between 30 and 40 kg/m², and lightweight ones drop to 22–28. More mineral mass means more rigidity, and everything else depends on rigidity. Ask for the weight per square metre on any quote you compare: it is the figure that best tells one tray from another, and almost nobody publishes it.
A tray that flexes ends up debonding from its base. When that happens it bridges on its edges alone, the perimeter silicone joint opens and water starts to escape at the side. It does not take much: a poorly levelled mortar bed with half a centimetre of unevenness is enough for a flexible tray to take the shape of the floor instead of its own. That is why we insist the base is flat before the tray is bedded; it is not a workshop fixation, it is the most expensive and most common failure.
This is the difference least often explained. A gel-coated tray gets its grip from a texture moulded into a surface layer a few tenths of a millimetre thick: once that layer wears or scratches, there is no anti-slip underneath. Ours is bush-hammered, meaning the texture is mechanically worked into the micro-marble itself, which is homogeneous throughout. Below the texture there is exactly the same material as on the surface, 30 mm down. And if it were ever needed, it can be bush-hammered again.
The thin point of any shower tray is the ring around the waste, and ours is no exception: no material saves you there. What prevents the problem is not the brand of the tray, it is leaving clearance under the waste when fitting it and not over-tightening. If anyone tells you their tray is indestructible in that area, be sceptical.
We listen to your project and take exact measurements.
We propose materials, finishes and edges, with a clear quote.
We craft each piece to measure in our own workshop.
We hand over the finished pieces for your builder to fit.
As we make everything to measure, the shelves, the shower niche, the basin top and the wall facings can all come out of the same material as your shower tray. It is a decision most people do not have in mind when they start the refurbishment, and it changes the result completely: the bathroom stops reading as separate pieces from different suppliers and starts reading as one. And because the pieces are cut from the same batch of material, the tone matches for real — something you cannot achieve by buying each piece somewhere else.
Send us your measurements and we will prepare a made-to-measure quote.